...
The PC/Mac and your MEGA65 need to be connected to the same ethernet network.
IPv6 needs to be enabled on the network interface on your PC/Mac (this is default but you may have changed it)
Hardware configuration
The DIP switch #2 on your MEGA65 mainboard needs to be set to ON.
| Info |
|---|
This step is not necessary for MEGA65 (R6) produced in 2024 and delivered from batch #3. |
...
. |
Unplug any cables attached to the MEGA65 (power, video, etc.)
Turn the MEGA65 to the back side and open the housing by removing the three lower screws:
Locate the DIP switch on the right side of the mainboard:
Use a small screwdriver or a pen to set DIP switch #2 to ON position. Be aware the DIP switch is up-side-down.
Close the housing, put back the three screws and plug all cables.
...
Head tohttps://builder.mega65.org/job/mega65-core/job/development/where you can find all development cores.
Any mega65-core from development branch dated October 10, 2023 or later should work.
Download the correct file for your MEGA65 model:DevKit, batch 1 and 2 owners : mega65r3 core
Batch 3+ owners (MEGA65 received in 2024+) : mega65r5 core
Unzip the core package after download and copy file ETHLOAD.M65 (in /sdcard-files) into the root folder of your SD card.
Install the core in slot 1-7. If you are not familiar with how to install a core read this Article.
...