Versions Compared

Version Old Version 5 New Version 6
Changes made by

Tayger

Tayger

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Hardware requirements

...

  1. Make sure the MEGA65 is connected to your PC (by USB cable) and turn it on (keep it on for the further steps)

  2. Head to https://www.ftdichip.com/Drivers/D2XX.htm and download the most top D2XX driver from the list Currently Supported D2XX Drivers :
    Windows / x64 (64-bit) -> 2.12.36.4 (or just highest version available)

  3. In the Device Manager of Windows there are two unknown devices marked red (labeled as Universal Serial Bus controllers). You need to install drivers for both devices:

    1. Choose search on my computer for new drivers

    2. Choose the location of the downloaded D2XX drivers from step 2

    3. Choose/install the Serial Converter B

  4. After driver installation for both devices two red marked Ports (COM & LPT) will appear. You also need to install the drivers for them. Proceed the same way described in step 3.

  5. If none of the devices are no more marked red everything should be fine. Start M65Connect (with admin rights) and test if it's working now.You’re ready now to connect the MEGA65 to your PC by M65Connect. More details on : Connect PC to MEGA65

Sending Bitstream files

For sending Bitstream files xc3sprog will be used by default. You don't need to install it as it's already included in M65Connect. If you want to send Bitstream files much faster or program VHDL you need to download and install Vivado or Vivado Lab: https://www.xilinx.com/support/download/index.html/content/xilinx/en/downloadNav/vivado-design-tools/2019-1.html (account required)

You can set the Vivado path later on. If not set xc3prog will then be used by default. You can install Vivado/Lab later on and search/set the path to it in Settings > File Paths.

As Vivado comes with its own USB serial driver you need to instlall them manually if you are not using Vivado. The driver installation manual can be found here: M65Connect/readme_driver_installation.txt

Important note: If you have an existing Bitstream in Slot 1 it will be started instead the loaded Bitstream by xc3prog. But you can skip this by holding key NO SCROLL while transferring the Bitstream, so that it stops in the Flash Menu on restart. Then you can just press key RUN/STOP to boot normally the loaded Bitstream without trying to load from the Flash menu.

...