The Terminal mode is activated by default and allows you to communicate with the MEGA65 by a set of predefined commands. Be aware that the Terminal mode is available only for JTAG connection.
Use the Command field below the Console window in order to communicate with your MEGA65
After pressing the ENTER key your command will be sent to the MEGA65. The answer will be displayed in the Console window.
Command list
You can enter these commands to interact with the MEGA65 (some are case sensitive). HexAddr doesn't need a prefix. All values are interpreted as HEX values. Space between Command and HexAddr is not required.
Command | Parameter | Description |
|---|---|---|
b | HexAddr | Set breakpoint (experimental) |
d | HexAddr | Disassemble line with HexAddr |
D | HexAddr | Disassemble 16 lines starting with HexAddr |
f | AddrLow, AddrHigh, Value | Fill memory area between AddrLow and AddrHigh with Value |
g | HexAddr | Set PC to HexAddr (16bit value) |
h | Help (show Bitstream version) | |
m | HexAddr | View memory at HexAddr |
M | HexAddr | View memory 16 lines beginning from HexAddr |
r | Show Register values | |
s | HexAddr, Value | Set Value (Byte) into memory address HexAddr |
t | Show Register values | |
tc | Continuous CPU trace (enter another command to stop) | |
t1 | Pause CPU | |
t0 | Resume CPU | |
z | [Index] | CPU execution tracing (experimental) |
! | Reset MEGA65 |