The Terminal mode is activated by default and allows you to communicate with the MEGA65 by a set of predefined commands. Be aware that the Terminal mode is available only for JTAG connection.
Use the Command field below the Console window in order to communicate with your MEGA65. After pressing the ENTER key your command will be sent to the MEGA65. The answer will be displayed in the Console window.
COMMAND LIST
You can enter these commands to interact with the MEGA65 (some are case sensitive). HexAddr doesn't need a prefix. All values are interpreted as HEX values. Space between Command and HexAddr is not required.
Command Parameter Description
b HexAddr Set breakpoint (experimental)
d HexAddr Disassemble line with HexAddr
D HexAddr Disassemble 16 lines starting with HexAddr
f AddrLow, AddrHigh, Value Fill memory area between AddrLow and AddrHigh with Value
g HexAddr Set PC to HexAddr (16bit value)
f Help (show Bitstream version)
m HexAddr View memory at HexAddr
M HexAddr View memory 16 lines beginning from HexAddr
r Show Register values
s HexAddr, Value Set Value (Byte) into memory address HexAddr
t Show Register values
tc Continuous CPU trace (enter another command to stop)
t1 Pause CPU
t0 Resume CPU
z [Index] CPU execution tracing (experimental)
! Reset MEGA65